Chip (SOIC8) Module L6 for 2 rotary

DC-Car microchip with DIP-8 encapsulation.

The L6 module performs 2 simultaneous sweeps of 3 lights at different speeds, to control 2 Rotating lights.

The anodes (positive poles) of all LEDs are joined between all them and connected to the output + of the DC-Car decoder voltage transformer. The resistance values are between 330 ohms and 470 ohms, depending on the desired brightness. As only one LED is lit at a time on each rotary, only one resistance is required on the positive pole of each rotary.

The module control is normally carried out by means of one of the decoder's flash outputs, without resistance. In the example scheme, the flash output 3 has been used. The CV of the corresponding output must be changed to continuous light output (255) without flashing.

PIN 1: Rotary 1 Led 1
PIN 2: Rotary 1 Led 2
PIN 3: Rotary 1 Led 3
PIN 4: Negative
PIN 5: Rotary 2 Led 1
PIN 6: Rotary 2 Led 2
PIN 7: Rotary 2 Led 3
PIN 8: Positive (3'5 / 5 V DC)