Vehicle decoders

Decoder DC08-I

DC08-I

New product

Up to 12 outputs for lights (1 of them can control a servo)

For vehicles with 3.6 V batteries

More details

Attention: Last unit in stock!

40,00 € tax incl.

Data sheet

Width6 mm
Long15 mm
Sistema de controlDigital DC-Car
Working Voltage3,6V

More info

Analog or digital operation with DCC protocol.

28 speed steps. Adjustable acceleration and braking.

Short and long digital address (1-127 / 128-9999) factory default: Address 1.

Infrared anti-collision system, can be deactivated through a function.

For vehicles with 3.6 V batteries (This decoder does not have a voltage converter).

Decoder ready to work: Factory pre-programmed CVs with the most common values.

Possibility of control from 8 meters away by LCIR of 455 kHz.

Supports reed NO/NC (with 10K? resistor) or even without reed.

It can control one servo.

An automatic stop can be programmed: The vehicle stops on a permanent magnet, then makes a sequence of programmable lights, and continues driving after a programmable time.

It can work as a master decoder: It is possible to control a slave decoder in a trailer, which is connected using 2 wires (or 3 wires) through the programming connector, so that the trailer can be fully disengaged.

Most outputs include an internal resistance, so LEDs can be connected directly. Some outputs require an external resistance to connect the LEDs.

Up to 12 outputs (3 of them multi-function MF):

- Light 0 Front position
- Rear position light
- Extra brake light that is activated when slowing or stopping. Adjustable time (CV 63). The output can be connected to the rear position light or to an extra red light
- Left direction blinker (or fixed, through CV 30)
- Right direction blinker (or fixed, by CV 31)
- 3 programmable emergency lights: fixed or various types of flashes (The outputs require resistance)
- Light 2
- Output MF1: Light 4 or servo
- MF4 output: Hall sensor or light 6 (Requires resistance) (CV 25)
- Output MF5: XT Infrared Emitter or light 7 (CV 25)


Functions:
F0: Front light + Rear light
F1: Blinker Left (steady light if CV30 = 0)
F2: Blinker Right (steady light if CV31 = 0)
(F1 + F2 = Emergency flashers)
F3: Ignore front anti-collision
F4: Ignore reed switch
F5: Emergency lights "Flash 1+2" (They can also be fixed lights)
F6: Front flash "Flash 0" (steady light if CV38 = 255)
F7: Light 2
F8: Light 4 (factory value CV 20 Bit 4 = 0)
F9: Light 4 (only if CV 20 Bit 4 = 1)
F11: Light 6 (only if CV25 Bit 5 = 1)
F12: Light 7
F13: Deactivate rear anti-collision

List of CVs in English (December 2014)

List of CV's in German (February 2017)